Search Results - Swedespeed
Username
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    Search:

    Type: Posts; User: ScottishBrick

    Page 1 of 34 1 2 3 4

    Search: Search took 0.21 seconds.

    1. Replies
      35
      Views
      651

      Hardly. Grandma driven T5Ms have 0.030Ē play at...

      Hardly. Grandma driven T5Ms have 0.030Ē play at 100k. The dual mass flywheel is a wear item and should be replaced every 100k. If you care about clutch feel. If not, **** it.
    2. Replies
      35
      Views
      651

      Gear chatter at idle. Because of the firing...

      Gear chatter at idle. Because of the firing order. Redline shockproof helps a lot.
    3. Replies
      8
      Views
      154

      Turbo Oil Feed Line

      Right but your new engine is a 00.

      I have that line but shipping will be annoying you may be better off to get it new theyíre not very expensive.

      What water pipe is in use?
    4. Replies
      8
      Views
      154

      Your engine is an 00 block? Should be the same...

      Your engine is an 00 block? Should be the same oil line as all p2 with td04. Its only 99 RN that has the ports for oil squirters that interferes with the line.
    5. Replies
      5
      Views
      154

      https://www.facebook.com/marketplace/item/34478588...

      https://www.facebook.com/marketplace/item/3447858888571007/
    6. 02+ Type 7cm^2 Angle Flange 16T Turbo w/74k

      Scored this extremely good condition 16T this weekend.

      From a 2004 C70 with 74k.

      This turbo has the most desirable angled flange 7cm^2 exhaust housing and the coolant ports are set up for 2002+...
    7. Replies
      2
      Views
      223

      Pic would be helpful: ...

      Pic would be helpful:
      ...
    8. Replies
      7,857
      Views
      380,617

      Use the emergency Jack! Pop the bump stop off,...

      Use the emergency Jack! Pop the bump stop off, place it on that pad, hook the lift point under the bump stop ďcatchĒ and then you can dial in the height exactly as necessary.
    9. Theyíre different sedan and wagon.

      Theyíre different sedan and wagon.
    10. Replies
      2
      Views
      223

      Japanifolds

      Got some nice ones yesterday.

      Sound and flow upgrade for any non factory equipped car. Better than N or 2.5t manifolds.

      Cast stainless doesnít crack.

      $80 plus shipping as usual.
    11. Replies
      3
      Views
      76

      ECU canít talk to the scanner and run the car at...

      ECU canít talk to the scanner and run the car at the same time. Iíve had this with VIDA and obd2 scanners. Would assume itís normal
    12. I also see a K24 oil feed line peaking out in the...

      I also see a K24 oil feed line peaking out in the pic. Itís a B5244T5.
    13. B5244T5 is dual vvt (R head) while all other...

      B5244T5 is dual vvt (R head) while all other B5244T(X) variants are single exhaust vvt.

      Should have a 05+ manifold.

      Should be setup for ETA not ETM.

      Should have the later thermostat and...
    14. Its been a bad week for the Volvo fleet

      The flywheel bolts are normal thread. Itís not torx itís XYZ or triple square.
    15. Replies
      6
      Views
      268

      Fair price. Inspect the starter bracket for...

      Fair price. Inspect the starter bracket for damage specifically and all mounting ears as well as the case
    16. Replies
      6
      Views
      268

      M56lk. Need to keep the gear ratios for cruise to...

      M56lk. Need to keep the gear ratios for cruise to work.

      20 spline is early, 23 spline is later on. Youíll need to replace the flywheel and clutch and the new trans will dictate that
    17. Last 6 of your vin. VIDA lists the spline count...

      Last 6 of your vin. VIDA lists the spline count split.
    18. The flywheel can be had for considerably less....

      The flywheel can be had for considerably less. Figure out if you have a 20 or 23 spline trans as well cause that alone cuts the price by half again.
    19. Replies
      20
      Views
      1,133

      Sold

      Sold
    20. Replies
      21
      Views
      765

      Need to see the maintenance records to make any...

      Need to see the maintenance records to make any kind of call. V8s are great but itís pay to play.
    21. Glad to hear it! Yes these fix a myriad of design...

      Glad to hear it! Yes these fix a myriad of design issues incredibly easily.
    22. One more in stock.

      One more in stock.
    23. Replies
      1
      Views
      223

      Sold

      Sold
    24. Fix it. Good learning experience and not that...

      Fix it. Good learning experience and not that hard. It will be more expensive than that because you need a new clutch and flywheel BUT if itís early enough you can use an 850 single mass and 850R...
    25. Theyíre sitting on the floor in front of my work...

      Theyíre sitting on the floor in front of my work bench, to be dealt with this week
    26. No. Swap away.

      No. Swap away.
    27. Replies
      1
      Views
      78

      XC options or just 17Ē p2 wheels

      XC options or just 17Ē p2 wheels
    28. Calipers, rotors, pads, lines. Itís effectively...

      Calipers, rotors, pads, lines. Itís effectively base Xc90 brakes.

      If you were looking for 305mm brackets which is just a bracket/rotor change thatís super easy. I can easily get a set of those...
    29. 316mm was a factory option later on and clears...

      316mm was a factory option later on and clears all 17s.
    30. Either way, thatís one of the upgraded housings...

      Either way, thatís one of the upgraded housings thatís stainless and has the better transition from the manifold for flow
    Results 1 to 30 of 1000
    Page 1 of 34 1 2 3 4