Search Results - Swedespeed
Username
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    Search:

    Type: Posts; User: deano66

    Page 1 of 5 1 2 3 4

    Search: Search took 0.02 seconds.

    1. Replies
      19
      Views
      648

      Hi Magnum Sorry to hear about your experience,,...

      Hi Magnum
      Sorry to hear about your experience,, $4,400? Ouch!
      Unfortunately most of the parts you list are on the normal side of maintaining this gen of Volvo.
      Only thing I see that tweaks my...
    2. Replies
      11
      Views
      571

      Good To hear the job went as planned!! Cheers!

      Good To hear the job went as planned!!
      Cheers!
    3. Thread: No fog lights?

      by deano66
      Replies
      9
      Views
      281

      I had this issue with my S60 so i gathered switch...

      I had this issue with my S60 so i gathered switch and lights from donor car used the pre-wire that existed and no joy.
      Is this a dealer option that needs to be turned on with a VALID subscription of...
    4. Codes? Bad gas? Last fuel filter change?...

      Codes?
      Bad gas?
      Last fuel filter change?
      Sorry,,not much to work with here...
      Cheers
    5. More good info here...

      More good info here
      https://forums.swedespeed.com/showthread.php?620189-Timing-Belt-started-but-hit-the-brakes

      Also Consider changing belt tensioner while doing T belt, it's usually tensioner or...
    6. Replies
      10
      Views
      451

      Cool! What engine is that going on?

      Cool!
      What engine is that going on?
    7. Replies
      11
      Views
      571

      At this point you half two options Spin engine...

      At this point you half two options
      Spin engine until crank mark lines up with marks on engine casting and cam notches for lock are lined up. These are your marks for "this" engine. Install cam lock...
    8. Replies
      11
      Views
      571

      So your engine is currently running fine and you...

      So your engine is currently running fine and you just want to do belt/tensioners and pump plus track down any leaks?
      I would start by degreasing the area with brake clean so everything is totally...
    9. Replies
      11
      Views
      571

      Hey JonE Cautious is the way to proceed for sure...

      Hey JonE
      Cautious is the way to proceed for sure in these instances but if you've done a timing belts before then the only thing different on the VVT engines is some of them have spring loaded hubs....
    10. AS far as resonator delete I've had mixed...

      AS far as resonator delete I've had mixed success. So resonator delete and increase muffler tailpipe diameter is what i did.
      Maybe depends on engine I'm not sure?
      On my B5244S + M56 S60 the sounds...
    11. That is a sweet ride and yes It's getting harder...

      That is a sweet ride and yes It's getting harder to find the low mileage unmolested examples at a decent price.
      Thanks for the tip on the Magic Eraser ,,, I'm always looking for proven cleaning...
    12. Replies
      45
      Views
      1,224

      Just wondering how many rags per mile your...

      Just wondering how many rags per mile your getting?:p
    13. Replies
      45
      Views
      1,224

      The upside to all this is maybe that rag wiped up...

      The upside to all this is maybe that rag wiped up some oil the usually accumulates in those pipes;)
      Cheers
    14. Replies
      45
      Views
      1,224

      When my wifes 2001 V70 was acting up recently it...

      When my wifes 2001 V70 was acting up recently it ended up being corroded pins at the ECM/harness junction and not allowing ECM to accept information accurately.
      The solution was to unseat {special...
    15. Replies
      7
      Views
      268

      I had to change the front "free wheel" bearing on...

      I had to change the front "free wheel" bearing on the compressor because of pretty obnoxious noise one time.
      Not a standard bearing either but they are available. 35mm x 55mm x 20mm.
      Careful,...
    16. o2 sensor failure will not cause the poor running...

      o2 sensor failure will not cause the poor running condition you've described.
      If your car's upstream goes bad and gives improper readings then ECM will ignore the sensor then throw a Cel and...
    17. Replies
      45
      Views
      1,224

      BigTime The MAF's are the same on your 2004 and...

      BigTime
      The MAF's are the same on your 2004 and 2002?
      Just swap em back and forth,,should be easy process of elimination.
      Your fuel filter has been serviced?
      So curious to know what's bugging...
    18. I've had good luck with correcting 3 poorly...

      I've had good luck with correcting 3 poorly behaving Aisin Warner units by only removing 3 main solenoids and sending them for rebuild here https://www.transmissiontechnology.ca/
      Jay and Carlos know...
    19. Replies
      45
      Views
      1,224

      Just read this "Unplugging MAF made no...

      Just read this
      "Unplugging MAF made no difference"??
      Swap in a spare! Unpluggin it should make a difference!
      You have yards open?? All closed here.:confused:
      If you have 40-60psi of fuel pressure...
    20. Replies
      10
      Views
      365

      So it all went together and refilled coolant and...

      So it all went together and refilled coolant and O rings are holding as they should.
      On a side note while trying to assemble with O rings all lubed and installed on heater tube I was unable to get...
    21. Replies
      10
      Views
      365

      Below is the measurement taken from new Volvo O...

      Below is the measurement taken from new Volvo O ring.
      Heater pipe measurement was around 18mm O ring ID measurement 17mm.
      O ring OD comes in around 22mm and thickness about 2.5mm or .100"
      I hope...
    22. Replies
      10
      Views
      365

      Okay gentlemen these "O" ring are the standard...

      Okay gentlemen these "O" ring are the standard run of the mill ring like P80.
      These are the ones i removed with rectangular profile.
    23. Replies
      45
      Views
      1,224

      That P0301 code? That's is "misfire cyl 1" I...

      That P0301 code? That's is "misfire cyl 1" I guess.
      So if it's just one dead cyl it should still start and run but with a bit of a lope. ;)
      What DentedHood mentioned is great info and while you're...
    24. Replies
      4
      Views
      151

      If it's dark grey and has hinge top maybe we can...

      If it's dark grey and has hinge top maybe we can make a deal!
      can you send me pics? Please private message me for contact info.
      cheers
    25. Replies
      45
      Views
      1,224

      Is this turbo car? Check all your turbo...

      Is this turbo car?
      Check all your turbo pressure hoses leading to to ETM.
      I had a badly rusted clamp that finally let go one time and engine did the similar thing.
      Cheers
    26. Replies
      4
      Views
      436

      Zak If it's withing spec I would not hesitate to...

      Zak
      If it's withing spec I would not hesitate to reuse it!
      Wait!
      I did reuse DMF on my s70 t5 when i had it apart for rear main seal and that was the first time I'd seen a DMF.
      Like you, I did...
    27. Replies
      7
      Views
      918

      These Guys are all spot on! All wheels driving...

      These Guys are all spot on!
      All wheels driving is great when it's working but personally love my front drive's for maintenance simplicity and maintenance costs.
      I've bought and sold my awd's...
    28. Replies
      4
      Views
      151

      Yeah I appreciate the thought but crossing the...

      Yeah
      I appreciate the thought but crossing the border will get you put in jail these days:nono:
      Once the scrap yards re-open here i should be able to locate one without to much difficulty but 'til...
    29. Replies
      4
      Views
      151

      P2 V70 Dark grey/grapghite center console

      Specifically the storage compartment hinge top thingy,, but I'll take whole thing.
      I'm in southern Ontario so keep that in mind. shipping would be ridiculous so probably need to do pick up locally....
    30. Replies
      4
      Views
      246

      Factory 2001 v70 t5 NAV system

      This thing is really antiquated... Surprised it still works, just not sure if I'll ever use it for it's intended purpose.
      Obviously it's a dvd rom but can it be used as a 6 CD changer instead?
      I...
    Results 1 to 30 of 147
    Page 1 of 5 1 2 3 4