Search Results - Swedespeed
Username
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    Search:

    Type: Posts; User: Canadian Moose

    Page 1 of 14 1 2 3 4

    Search: Search took 0.03 seconds.

    1. Replies
      5
      Views
      136

      I have all the parts required for the swap. Was...

      I have all the parts required for the swap. Was only concerned about the ECU part.
    2. Replies
      5
      Views
      136

      K24 question

      Stock turbo on my 2.4 is leaking oil and I was planning on swapping to K24 down the line. I know I will need a tune when I do this but can I put K24 on there now and do the tune later? Is the ECU...
    3. Replies
      7,105
      Views
      335,799

      Swapped ABS rings, both axle seals in the trans,...

      Swapped ABS rings, both axle seals in the trans, replaced water pump, installed Intrepid sway bar links and did an oil change.
    4. My 01' M56 with single mass fly wheel also...

      My 01' M56 with single mass fly wheel also chatters in neutral with no clutch applied. I learned to live with it.
    5. Replies
      12
      Views
      355

      I painted mine myself. Had a local spray shop mix...

      I painted mine myself. Had a local spray shop mix me a spray can to match my car and topped it off with 2k clear from a spray can made by SprayMax. Also got it from same paint shop. Price of paint...
    6. Replies
      3
      Views
      206

      Honestly you best bet is to get brand new units....

      Honestly you best bet is to get brand new units. I've gone through several used motors before I found a set that works. The motors usually don't break in them, it's the linkages inside that wear out...
    7. I think I figured out source of the noise. The...

      I think I figured out source of the noise. The bearings are not pressed into housing but rather just sit there in an opening and held in place with a clip so they have the ability to spin. I believe...
    8. Noisy blower motor - is there a fix?

      Every single P2 that I've owned and been in had the dreaded noisy blower motor. When it's at low or moderate speeds there is a dreaded screech. When on high speed the noise goes away. Replacing seems...
    9. You don't even need a template. There are targets...

      You don't even need a template. There are targets engraved in the lid showing where to drill.
    10. Like mentioned above no need to take the dash...

      Like mentioned above no need to take the dash out. Pull the cluster then use a long extension with a swivel to get to the bolt. Don't recall if I had to take the gas pedal out to get it out but...
    11. I scoop up wings at the wreckers as soon as I see...

      I scoop up wings at the wreckers as soon as I see them. Easy money.
    12. Replies
      5
      Views
      232

      Vida will do it.

      Vida will do it.
    13. Replies
      5
      Views
      219

      Next time I go to one I can check. There are...

      Next time I go to one I can check. There are usually a couple manual cars around. Might be a while though.
    14. Replies
      5
      Views
      219

      Your best bet is a junkyard.

      Your best bet is a junkyard.
    15. Replies
      33
      Views
      1,308

      I towed another V70 with my V70. This should be a...

      I towed another V70 with my V70. This should be a walk in the park for XC90.
    16. Replies
      29
      Views
      780

      Ditch the plastic pulley for a steel one. Mine...

      Ditch the plastic pulley for a steel one. Mine actually shredded on the way to work one day. I was lucky it didn't take anything else out with it. I swapped to a steel Cadillac pulley.
      ...
    17. Replies
      33
      Views
      1,308

      Rust would be a deal breaker for me. The bodies...

      Rust would be a deal breaker for me. The bodies on these are usually very good and unless there was prior collision damage I would expect rust to be minimal even on a rust belt car. P2 T5s are not...
    18. Replies
      3
      Views
      344

      I am in Ontario. Shipping will likely be quite a...

      I am in Ontario. Shipping will likely be quite a bit judging how large the console is.
    19. Replies
      18
      Views
      655

      The XC seats don't have the extra bolsters though...

      The XC seats don't have the extra bolsters though and aren't as supportive imo.
    20. Replies
      3
      Views
      344

      2007 V70 rear seat entertainment

      Selling rear seat entertainment system out of 07' V70. Comes with center console with DVD player, headrests with monitors, remote control, headphones (1 is damaged), center dash speaker, amp,...
    21. Replies
      7
      Views
      332

      Dash switches

      I am monkeying around with my climate controls and was curious if it matters which slot the buttons are plugged into. Anyone know? Can I move the buttons around and still have them function as...
    22. Swap the seals and call it a day. These engines...

      Swap the seals and call it a day. These engines are tanks.

      If you are doing the timing belt might as well do water pump and tensioner.
    23. What model did the cast iron arms come from?

      What model did the cast iron arms come from?
    24. Replies
      7
      Views
      261

      Interesting. The one I saw has a single DVD...

      Interesting. The one I saw has a single DVD player integrated into the center console. Came with headphones and remote. Looking at the manual it seems to be mostly standalone apart from speaker...
    25. Replies
      7
      Views
      261

      Rear seat entertainment

      How rare is rear seat entertainment system? I found a complete system out of 07' V70 and was curious if it can be retrofitted into my 2002.

      This is the system I am referring to....
    26. Replies
      18
      Views
      620

      I don't know, what do they look like? There are...

      I don't know, what do they look like? There are turn signal indicators in the front and lights underneath.
    27. Replies
      3
      Views
      182

      I guess the other option would be to get OEM...

      I guess the other option would be to get OEM replacement and fill it with liquid urethane.
    28. Replies
      3
      Views
      182

      Urethane right lower engine mount?

      My right lower engine mount has failed and needs replacing. All I am finding is regular rubber. My upper mount and front tranny mount are urethane already and I'd like to keep going in that...
    29. Replies
      18
      Views
      620

      Guess the $25 I paid at the wreckers wasn't a bad...

      Guess the $25 I paid at the wreckers wasn't a bad deal. :)
    30. Replies
      18
      Views
      620

      Nice. I grabbed wiring pigtails just in case.

      Nice. I grabbed wiring pigtails just in case.
    Results 1 to 30 of 395
    Page 1 of 14 1 2 3 4