OBD, CANBUS & Engine Management Forum Suggestion Box
Username
Do you already have an account?
Forgot your password?
  • Log in or Sign up

    Results 1 to 4 of 4
    1. #1
      Member MrTippy's Avatar
      Join Date
      Aug 2004
      Posts
      4,018

      OBD, CANBUS & Engine Management Forum Suggestion Box

      Comments, Questions, Requests... You know what to do.
      '04 V70 NA -- gone

    2. Remove Advertisements

      Advertisements
       

    3. #2
      Junior Member
      Join Date
      Apr 2012
      Posts
      1

      2006 S60R Check Engine Codes ECM-310D, ECM-312D, ECM-313D

      I have a 2006 S60R with 6-speed manual trans. It's at the dealer (check engine light came on and then it immediately started sputtering) and I want to know what these codes mean: ECM-310D, ECM-312-D, ECM313-D. Since the numbers are close, I am assuming that they are related. I think it is electrical or fuel management. Is there a site I can go to, to find out or is there someone out there who knows what these codes mean? I really would appreciate the help. Just want to keep the dealer honest.

    4. #3
      Junior Member
      Join Date
      Apr 2005
      Location
      Kent, WA
      Posts
      773
      Wrong place to post this question, but

      ECM310D means a misfire.
      ECM312D and ECM313D do not exist.
      ECM 321D means misfire in cylinder #1
      In this sequence, the last number before the D means which cylinder is misfiring.

      This is from looking at VIDA diagnostic codes.
      '05 S60 T5 Manual, 232K miles, just totaled, still driveable; '00 S70 T5 M 210K miles; former race cars: 544, 122, 142

    5. #4
      Junior Member
      Join Date
      Sep 2015
      Posts
      1

      Exclamation Headlamp problem

      Hi!

      I`m have heard about this forum, but only recently decided to join in. Currently I have a Volvo S60 MY07 with sports package. But, I have a bit of a problem with my headlamps and I was hoping someone over here could hep me. My S60 has Volvo ABL headlamps and one of them is not turning in corners as it should. I have changed the part that moves in it with block (part No. for block under moving part 89038337), it now knows it`s position, but still doesn`t bend in cornerns, but when I try to bend with hands it comes back at it`s start position. At the moment MaxiDAS reads 2 fault codes and maybe someone can help me by explaining them:

      4078 Lamp unit Wrong mounting positions
      and
      DD10 Communication with left-hand lamp module (LHCU) signal missing.

      Any ideas why is this so? I would really appreciate some help, because I am stuck with this.
      Also, sorry if this isn`t the right place to post it, but I couldn`t find a better one.

    6. Remove Advertisements

      Advertisements