Welcome to SwedeSpeed
You're currently browsing Swedespeed as a guest. Please sign up or sign in and take part in the conversation with other Volvo owners and enthusiasts. With more than 2 million posts our community is one of the most active groups of Volvo owners in the world. Take a moment to sign up and enjoy all of the features our forums have to offer.
-
XC70 lower door cladding removal
Anyone done this? Is it the same as on a V70, e.g. three Torx 25 bolts and a couple of snap in plastic holders along the bottom edge, or are they glued or otherwise fastened up higher on an XC70?
Thanks
-
-
They are glued and have 2-3 t25s under the panel I believe. I’ve done it on an xc70. Just be careful not to bend or flex the plastic too much as it’s easy to do if you miss a t25.
Sent from my iPhone using Tapatalk
-
Sounds like XC70 and V70 doors won't interchange then
-
-

Originally Posted by
zak
Sounds like XC70 and V70 doors won't interchange then
Doors are the same. Front doors will also interchange with a P2 S60 (NOT rear doors though)
Last edited by N.E. Swede; 11-17-2019 at 10:21 AM.
-
If the lower door moulding is glued along its upper edge, along with internal T35 bolts as Boosted suggests, then yes it may physically swap but won't look right, won't match the rocker moulding.
-
The lower mounting points on the door are the same for the mouldings (V or XC), top of the XC moulding is held with double sided mounting tape. XC moulding goes right on a V door with no problems. If you remove it carefully you won't even need to replace the mounting tape. Did this on my sister's XC, zero issues
-
Thanks. Am trying to go the other direction, mount XC70 rear doors on a V70, with V70 lower door cladding.
Suppose the double sided adhesive can be removed, though adhesive remover is hard on paint. Is it fairly narrow area?
-
The adhesive tape is narrow. Every XC moulding I've removed, the tape has stayed attached to the moulding, none left on the door. If some stays on the door you'll likely be able to roll it off with your fingers. You may end up with a slightly visible line where the tape was because the paint under it has never been exposed to sun/elements
-
Thanks, this opens several options locally, appreciate the info
-
Similar Threads
-
By CrossingCountries in forum V70 & XC70 (2008 - 2016)
Replies: 5
Last Post: 10-09-2015, 12:21 PM
-
By djeremya in forum V70 & XC70 (2008 - 2016)
Replies: 0
Last Post: 11-26-2012, 02:26 PM
-
By smartbabo in forum S40 & V50 (2005-2012)
Replies: 2
Last Post: 12-04-2005, 06:31 AM
-
By COMark in forum V70 & V70XC & XC70 (2001-2007)
Replies: 10
Last Post: 04-13-2003, 12:03 AM
-
By FrankG in forum The Detailing Forum
Replies: 3
Last Post: 10-16-2002, 01:13 PM