So I've spent a while looking online, and can't find anything. I have this great idea to wire a switch/button in one of the wires going to the TCV and then mount it in place of one of the blank buttons near the bottom of the center column. The idea being that (since I've been having issues when boost gets over 15psi) I can drive normally and be careful not to hit that 15 mark, but when I want to wring it out or give it to someone else to drive, I can just hit that switch and dump everything to the 5psi wastegate without having to dig around in the engine. My genius knows no bounds, I know.
The issue I have is that, after completely tearing apart the entire dash unit yesterday, circuit board and face plate off and everything, I still couldn't figure out how to remove one of the blank buttons from the unit. I think it would make my life a lot easier to have it out before drilling the hole, or maybe even turn it into a working button. Does anyone know how to remove these in a non-destructive manner?