Hi. I went to change the rear brake pads on my xc60 today. Being it's got the electric park brake, I normally would disconnect plug from caliper and using a battery, I'd wind the motors back.
But this time I thought I'd use some Delphi software and put the EPB into service mode. I now regret doing this as after replacing the brake pads I can now NOT get the EPB to come out of service mode. And I just get 'failed' shown on computer everytime i try to.
When I read fault codes only one I get is u210054, which I believe is normal, because the EPB is still in service mode and no calibration has been learned.
Can anyone help with this please or maybe point me in right direction.
Thanks in advance.